Thingiverse
Dragon Knocker
von grim86
1.8k
Downloads
1.5k
Likes
1
Makes
Remix of Shira's AWESOME design.
https://www.thingiverse.com/thing:1458545
Thanks Shira!
Since the original design is very nice modeled, but lack in fuctionality due to a too tiny ring, I remade it with a taller strike plate and separate, bigger ring with a more dense infill (+45%) to make it heavier.
The head must be scaled 70%, print the ring and the strike plate as is (plus support).
The ring (part A and part B) must be assembled with the two alignment pins (cube and cylinder) , inside the mouth of the dragon
https://www.thingiverse.com/thing:1458545
Thanks Shira!
Since the original design is very nice modeled, but lack in fuctionality due to a too tiny ring, I remade it with a taller strike plate and separate, bigger ring with a more dense infill (+45%) to make it heavier.
The head must be scaled 70%, print the ring and the strike plate as is (plus support).
The ring (part A and part B) must be assembled with the two alignment pins (cube and cylinder) , inside the mouth of the dragon
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
