Thingiverse
Dragon
door muzz64
1.7k
Downloads
1.4k
Likes
35
Makes
Easy print of a dragon with wings. This is the dragon equivalent of the popular MakerBot Mr. Jawz print. Square section so it prints flat on a raft.
Note: The orange dragon pictured is the final version. It has an additional spike on the top of its head compared to the green one.
If you like this take time to check out my other designs!
Tips: Tips are not expected but are appreciated as they help offset my filament costs as much as anything else. However, as I live outside the USA tips cannot be sent to me via PayPal.Me as that service is not supported in my region and this is beyond Thingverse's control. If you feel like sending a tip please use regular PayPal and send it to [email protected] and, to those who do, thanks in advance!
Note: The orange dragon pictured is the final version. It has an additional spike on the top of its head compared to the green one.
If you like this take time to check out my other designs!
Tips: Tips are not expected but are appreciated as they help offset my filament costs as much as anything else. However, as I live outside the USA tips cannot be sent to me via PayPal.Me as that service is not supported in my region and this is beyond Thingverse's control. If you feel like sending a tip please use regular PayPal and send it to [email protected] and, to those who do, thanks in advance!
muzz64 publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!