Dragonite

Find another version of Dragonite on my Patreon →here← and check out my other Pokemon models →here← Project: DragonitePrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.64mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mm This print uses 8 unique filamentsPLA BambuLab Matte Dark BluePLA BambuLab Basic Blue Gray PLA BambuLab Basic Bright Green PLA BambuLab Basic Turquoise BluePLA BambuLab Matte Scarlet Red PLA BambuLab Basic Orange PumpkinPLA BambuLab Matte Lemon Yellow PLA BambuLab Matte Ivory White Swap Instructions:Start with Dark BlueAt 0.72mm swap to Blue GrayAt 0.8mm swap to Bright GreenAt 0.96mm swap to Turquoise BlueAt 1.12mm swap to Scarlet RedAt 1.36mm swap to Orange PumpkinAt 1.52mm swap to Lemon YellowAt 1.76mm swap to Bright GreenAt 1.84mm swap to Ivory WhiteAt 2mm swap to Turquoise Blue for the rest.