Drawer bottom support

A small support bracket designed to add extra reinforcement underneath thin based Ikea style drawers. Great for if you find yours keeps popping out because of the weight of load you have in it.Print SettingsPrinter:Flashforge Creator ProRafts: NoSupports:NoResolution: 130microns / 0.4mmInfill:50%Post-PrintingThe hole is designed for a picture hook pin nail but is a tad tight to make sure it stays solid.I find the best thing to do is hammer the pin into the hole until it pokes a few mm out of the bottom, then hammer it into the front/back/side of the drawer until firm.This provides a surprising amount of support to the drawer!