Slicer Discord
Drawing Dead Insert – 3D-printbaar model van Thingiverse Thingiverse

Drawing Dead Insert

0 Downloads
0 Likes
0 Makes
Model downloaden
An insert for the Solo Game Of The Month _Drawing Dead_. This was a tough one because the two card sizes didn't fit comfortably together in the box in any orientation. This left little space for any sort of useful tray. If I wanted to optimize fitting in the box and no lid lift, then I'd have essentially been filling the gaps and couldn't sleeve any of the cards. In deciding to take an approach that prioritized setup and improving play I accepted that the original box would require lift. That freed me to embrace sleeves as well. The final decision I made was to “get rid” of the lift by creating a new bottom that fits snuggly into the box top.

Setup should be a breeze.

1. Open box
2. Place deck / token tray on the table in front of you.
3. Grab the characters and choose one. Set the rest aside.
4. Grab the Gates / Bosses / Minions tray and pull out the cards you need for the difficulty you're playing at, along with the 2 Penance tokens.
5. Remaining Gates, Bosses, Minions, and Charact
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

lovehasnologic publiceert ook op

41 extra modellen op 2 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie