Thingiverse
Drill Guide
by EvgenyF
21
Downloads
6
Likes
0
Makes
This is a drill guide for corded drill tool. It has a 43 mm mounting hole.
in addition to the printed details you will need 2 springs, 2 metall tubes and hardware.
for springs I used one 1x18x305mm Spring divided in two pieces. However it is not strong enough.
2 Al tubes 1x 14 x 27 mm
M6 hardware
Aluminum tubes were glued into base using epoxy.
in addition to the printed details you will need 2 springs, 2 metall tubes and hardware.
for springs I used one 1x18x305mm Spring divided in two pieces. However it is not strong enough.
2 Al tubes 1x 14 x 27 mm
M6 hardware
Aluminum tubes were glued into base using epoxy.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
