Thingiverse
Drill Guide
by anisb
54
Downloads
23
Likes
0
Makes
Drill guide to drill holes at 90deg. Fits my Dewalt DC740 (and probably many more, please have a look at the last pictures you'll find the hole dimensions of the clamp).
You'll need to fix two metal rods, 6mm diameter. These are the ones I bought:
[Metal rods](https://amzn.to/2Y75bDM)
The rods are friction fit on the base. I didn't need to glue them. The clamps needs to move easily, I had to enlarge its holes a little bit with my drill and used some grease.
Printed the base at 100% infill and only the bottom part of the clamp at 100% as well (up until where the rods come out). Drilled several vertical holes using a 6in bit and came out perfect.
*NOTE: Someone on reddit pointed out that there was a similar thing with another design, here is the link in case it better fit your needs: https://www.thingiverse.com/thing:4387534 *
You'll need to fix two metal rods, 6mm diameter. These are the ones I bought:
[Metal rods](https://amzn.to/2Y75bDM)
The rods are friction fit on the base. I didn't need to glue them. The clamps needs to move easily, I had to enlarge its holes a little bit with my drill and used some grease.
Printed the base at 100% infill and only the bottom part of the clamp at 100% as well (up until where the rods come out). Drilled several vertical holes using a 6in bit and came out perfect.
*NOTE: Someone on reddit pointed out that there was a similar thing with another design, here is the link in case it better fit your needs: https://www.thingiverse.com/thing:4387534 *
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!