Thingiverse
drink Coaster
von WHATSUP225
11
Downloads
43
Likes
0
Makes
the dimensions are 110.00mm by 110.00mm and a max 10.00mm high. it is higher on the side to stop drinks form sliding off.
(please like this design because this will be my last design for a month or two because i was using fusion 360 on a free trill and the free trill has pretty much ended. i will hopefully start designing again in a month or so when i should be able to get a 3d printer.)
(please like this design because this will be my last design for a month or two because i was using fusion 360 on a free trill and the free trill has pretty much ended. i will hopefully start designing again in a month or so when i should be able to get a 3d printer.)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!