Thingiverse
Drinking tap
von andrevanzolin
1
Downloads
2
Likes
0
Makes
Imprimir a peça conforme mostrado na foto da impressora. São dois modelos diferentes.
Camada: 0.15
Preenchimento: 10%
Sem rafts
5 linhas de Brim
Print the part as shown in the photo of the printer. There are two different models.
Layer: 0.15
Infill: 10%
Without rafts
5 lines of Brim
Camada: 0.15
Preenchimento: 10%
Sem rafts
5 linhas de Brim
Print the part as shown in the photo of the printer. There are two different models.
Layer: 0.15
Infill: 10%
Without rafts
5 lines of Brim
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
