Thingiverse
Driver bit holder
door themaninthesuitcase
69
Downloads
46
Likes
2
Makes
Bit holder for the spare belt hook screw ion your drill/driver. Holds 5 standard bits using the power of magnets!
Once printed simply press in the magnets, they are snug so may need a good shove.
This is to fit the **right** side of a driver, for the left simply mirror before slicing.
You will need:
5x 5mm diameter x 2mm tall Neodymium magnets.
1x mount screw.
For my Makita I used an M4x20 which is a shade long, 18mm would be better but you'll need to cut one down.
For Dewalt I believe they use M3 but check on your own tool.
Once printed simply press in the magnets, they are snug so may need a good shove.
This is to fit the **right** side of a driver, for the left simply mirror before slicing.
You will need:
5x 5mm diameter x 2mm tall Neodymium magnets.
1x mount screw.
For my Makita I used an M4x20 which is a shade long, 18mm would be better but you'll need to cut one down.
For Dewalt I believe they use M3 but check on your own tool.
themaninthesuitcase publiceert ook op
8 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
