Slicer Discord
Droid X2 Accessory – 3D-Druckmodell von Thingiverse Thingiverse

Droid X2 Accessory

von tbm0115
3 Downloads
4 Likes
1 Makes
Zum Modell
A clip-on accessory for the Android X2. This accessory redirects sound from the speaker towards the user and has a collapsable stand.
Update 08/09/2012: Just uploaded a new version. Haven't had a chance to print this one yet. Changes are rounded clips and extended along length of device and also the stand clasps onto a ring on the back.
Update 10/16/2012: I slightly changed the design to increase the strength of the lower half as the stress of taking the phone out and back in repeatedly wore down the corners. Also made the clips loose so the phone slides into place instead of wearing on the side of the phone. Might make it a little bit tighter so the phone doesn't completely fall out.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen