Slicer Discord
Drone Range Extender stabilizer – 3D-Druckmodell von Thingiverse Thingiverse

Drone Range Extender stabilizer

2 Downloads
1 Likes
0 Makes
Zum Modell
Drone Reflector Stabilizer
I have a DJI Phantom 3 Advanced and use a reflective range extender. I suspect the controller unit is similar for many DJI models. The weight of the reflectors is too great for the antennae to hold up. So this device offers support. I do not remember the brand of the reflectors, but others must be close, so altering the .stl can be easily done to make others fit. The reflectors increased my range from about ¾ miles to just over a mile. It works well, but you have to watch the direction of the drone since the range behind you is quite short, so you need to always point toward the drone.
Bob in Atlanta
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

BobinAtlanta veröffentlicht auch auf

5 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen