Thingiverse
Drone Workbench
par pmcloete
6
Téléchargements
6
Likes
0
Makes
Drone Workbench.
Mount your drone to the bench to easily remove props, do maintenance or just as a display piece.
I used the Diatone M540 to create this model but should work with most 5 inch drones.
To assemble:
I used threaded inserts and a small blowtorch to insert them into the drone mounting block.
The legs then just screw in with M3 screws and washers. I ended up using two part epoxy between the block and legs before fastening the screws and I am not planning on taking it apart again(This added a lot of rigidity to the assembly).
Link to the threaded insert:
https://www.banggood.com/100Pcs-M3-x-6mm-Brass-Knurled-Nuts-Insert-Female-Thread-Round-Insert-Embedded-Nuts-p-1184384.html?rmmds=myorder&ID=41528&cur_warehouse=CN
Mount your drone to the bench to easily remove props, do maintenance or just as a display piece.
I used the Diatone M540 to create this model but should work with most 5 inch drones.
To assemble:
I used threaded inserts and a small blowtorch to insert them into the drone mounting block.
The legs then just screw in with M3 screws and washers. I ended up using two part epoxy between the block and legs before fastening the screws and I am not planning on taking it apart again(This added a lot of rigidity to the assembly).
Link to the threaded insert:
https://www.banggood.com/100Pcs-M3-x-6mm-Brass-Knurled-Nuts-Insert-Female-Thread-Round-Insert-Embedded-Nuts-p-1184384.html?rmmds=myorder&ID=41528&cur_warehouse=CN
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
