Thingiverse
Drop-Side Crib Trigger Lock
door theheig
1
Downloads
1
Likes
0
Makes
Designed this trigger lock to replace a pair of OEM trigger locks that had broken on an older dropside crib.
Model should be printed with the "barrel" structure facing up. Model includes sprue structure to support the spring retainer "spike" which can be snapped/cut off carefully after printing.
Supports must be added around barrel.
Original spring:
- 30mm length
- 5mm outer dimension
- 0.6mm wire gauge/thickness
NOTE: While this part was ultimately printed using ABS, proofs were successfully created with PETG which I'd also consider acceptable keeping in mind that it will likely fail quicker than ABS.
Model should be printed with the "barrel" structure facing up. Model includes sprue structure to support the spring retainer "spike" which can be snapped/cut off carefully after printing.
Supports must be added around barrel.
Original spring:
- 30mm length
- 5mm outer dimension
- 0.6mm wire gauge/thickness
NOTE: While this part was ultimately printed using ABS, proofs were successfully created with PETG which I'd also consider acceptable keeping in mind that it will likely fail quicker than ABS.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!