Thingiverse
DS0138 Case
von simonbethke
13
Downloads
22
Likes
0
Makes
Some time ago I assembled my own DIY DS0138 which I bought without a case. Now after owning a 3D printer I wanted to get a case for it so I looked for cases. There were quite a few on thingiverse but non really seemed to be good to me. I also printed one and a half and they all had major drawbacks. Mostly, the construction of the sliding switches wasn't well enough thought through and this is really a tough topic as they are really far away from the display plane.
After all I decided to come up with an own case and thats what you can download and check here. It requires 4 M3-Screws of a length somewhere between 5mm and 20mm ;)
As this is a version 1.0 it has no fixes of basic issues. The Issues are:
* The screen cutout could have been a little smaller. Just check the photo
* The sliding switches and the push buttons require more post-print clean up than I wished. An easy fix for the pushbuttons would be to add a fase to the holes in the top panel.
Let me know what you think
After all I decided to come up with an own case and thats what you can download and check here. It requires 4 M3-Screws of a length somewhere between 5mm and 20mm ;)
As this is a version 1.0 it has no fixes of basic issues. The Issues are:
* The screen cutout could have been a little smaller. Just check the photo
* The sliding switches and the push buttons require more post-print clean up than I wished. An easy fix for the pushbuttons would be to add a fase to the holes in the top panel.
Let me know what you think
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
