DS0138 Digital Oscilloscope Case

This is a casement I designed for the DS0138 digital oscilloscope. It's a cheap one channel O-Scope which comes with just a circuit board and leads, and nothing else. This case makes it look nice and gives it some protection.

The original board has a protruded LCD board, with the buttons and switches mounted on the main board, so they're recessed from the face. I wanted a flat case, so there are caps printed out which slide on top of the buttons/switches.

A fair warning, they could be frustrating to install. I used some petroleum jelly (I actually used Burt's Bees hand cream, but you can use anything that has some tackiness to it just to hold the buttons and switches in place for a bit as you put the top case on.) I then used a small screw driver to move the switches and buttons into place from the top face of the case. But once the board is sitting inside of the top case, the buttons and switches work well and don't rattle around at all.

On the one I currently have, I didn't