Thingiverse
Duet3D Ethernet Case
par dlsmith57918
9
Téléchargements
6
Likes
0
Makes
I decided to use a Duet3D Ethernet boar and Duet3D display on my Hypercube build. There were a few cases out there for Duet boards, but none of them were small enough to build with my QiDi Tech 1, so I designed this one.I JUST fits, and I had to remove the priming strip after it was laid down, or it would be in the printing area.
There are two cases, one with pads to mount a modfet bed heater controller and one without. There are also two lids, one with a logo and one without. The lid is attached with #6 X 3/8" sheet metal screws.
The case has mounting holes and cutouts to mount an 80 fan to cool the board, although it runs ver cool as it is. In fact I need to put a PWM controller in the fan circuit to slow it down, as it is the loudest thing on the printer.
There are two cases, one with pads to mount a modfet bed heater controller and one without. There are also two lids, one with a logo and one without. The lid is attached with #6 X 3/8" sheet metal screws.
The case has mounting holes and cutouts to mount an 80 fan to cool the board, although it runs ver cool as it is. In fact I need to put a PWM controller in the fan circuit to slow it down, as it is the loudest thing on the printer.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
