Thingiverse
Duet3D Wifi Controller Box
door pcsentinel
85
Downloads
32
Likes
0
Makes
Box for the Duet Wifi Control Board, it incorporates labels and light pipes for the on-board LED's to bring them to the top of the box, just drill out the pipes and insert transparent filament.
The box has vent holes in the bottom and a sliding top lid (with vent holes) so that is can be slid back to get to the USB port and memory card.
Also included are the mounts I use together with an additional box that sits next to the control box and is used for looping all the extra cable.
In case you don't want the labels and light pipes then I've also included a blank lid.
The box has vent holes in the bottom and a sliding top lid (with vent holes) so that is can be slid back to get to the USB port and memory card.
Also included are the mounts I use together with an additional box that sits next to the control box and is used for looping all the extra cable.
In case you don't want the labels and light pipes then I've also included a blank lid.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
