Duet3D Smart Effector Cable Constraint

The wires plugged in to the Duet3D Smart Effector gets a lot of mechanical wear an tear as the nozzle moves over your prints and bends the cables running down from above. I've had a few service-runs because of this issue. PCB plugs are not typically designed to absorb movement..

This simple cable constraint clips around the plug on the PCB of the Smart Effector to tackle the issue. At least minimize it. I've had luck with it so far.

I haven't made one for the heater connector yet, cause the cables themselves are better attached and more sturdy. Time will show if I need one.