Thingiverse
DumboRC DDF-350 Side Knobs Large and Small
von ItsJustJoe
6
Downloads
4
Likes
0
Makes
Two different sizes of knobs for the DumboRC DDF-350 transmitter. They may fit other transmitters but I have not tried them.
You can use two of the small knobs or a large and small.
Printed in black PLA on a Flashforge Adventurer 5M at .12 Layer height.
I used 100% infill but it's not necessary.
You can use two of the small knobs or a large and small.
Printed in black PLA on a Flashforge Adventurer 5M at .12 Layer height.
I used 100% infill but it's not necessary.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
