DUMMY 13 Functional Backpack

This is a backpack for Dummy 13. Two versions are available: Version 1.0 - Fits Version 1.0 of Dummy 13Beta - Fits Beta version of Dummy 13It prints in two parts: the lid and the compartment. Printing will require supports for the peg, a threshold angle of 10 degrees should work nicely. Recommend using .12mm layer height or less to help with hinge fitment. Have been printing these in PLA but PETG may work better for hinge strength. The lid and compartment connect together using a pop hinge. The hinge pops in place by aligning the lid with the compartment in the closed position and pushing/wiggling the two parts together. The backpack can then be attached to Dummy 13 using the peg, which snaps into the square hole in the dummy's back. Use the hinge lock to tighten things up and keep the backpack closed. Hinge lock slides over the assembled hinge when in the fully open position, with flat bar inside the backpack and pointy ends outside, see pictures in gallery. Video of assembly can