Thingiverse
Duofan
von ehj
2
Downloads
3
Likes
0
Makes
This fan duct uses left-over space that is available in the front right corner of the printer. It exactly fits an additional axial fan and will not bump into anything while printing.
The weight is approx 50g. That is for plastic parts plus screws, two fans, and wire.
I think there is sufficient room inside to mount some led's to light up your nozzle too (next project)
The weight is approx 50g. That is for plastic parts plus screws, two fans, and wire.
I think there is sufficient room inside to mount some led's to light up your nozzle too (next project)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
