Thingiverse
DX COMMANDER / SPIDERPOLE BASE
par chopcat
55
Téléchargements
27
Likes
0
Makes
OK the missing part of the equation.
Having left half my dx commander base bit at the mother in laws I needed to make up another one so set about making it in a single bit that would also work with the 12M Spiderpole.
It is made in 2 bits that clip together and are secured with a bit of CA.
I made up the ring from a 125mm x 3mm ali disk from ebay and chopped a hole in the middle. You can leave the base disk whole. I threaded the bolts in but as there is some plastic for the thread to bite into you might get away with out doing that.
There are a couple of wires from the PL259 connector with eyes crimped on to connect to the top and the bottom and that's about it.
So this goes with the universal spacer rings
https://www.thingiverse.com/thing:4081868
and wire winders
https://www.thingiverse.com/thing:4082284
Having left half my dx commander base bit at the mother in laws I needed to make up another one so set about making it in a single bit that would also work with the 12M Spiderpole.
It is made in 2 bits that clip together and are secured with a bit of CA.
I made up the ring from a 125mm x 3mm ali disk from ebay and chopped a hole in the middle. You can leave the base disk whole. I threaded the bolts in but as there is some plastic for the thread to bite into you might get away with out doing that.
There are a couple of wires from the PL259 connector with eyes crimped on to connect to the top and the bottom and that's about it.
So this goes with the universal spacer rings
https://www.thingiverse.com/thing:4081868
and wire winders
https://www.thingiverse.com/thing:4082284
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
