Dynavap induction heater

a custom minimal case for the classic DIY induction heater parts found all over r/dynavap. The design is open sourced on tinkercad, so you can easily change anything about it: https://www.tinkercad.com/things/8lEaxVs6iTa

I've built this design a few times and run over 100 cycles without any issues. I've printed it in PLA so I could visually verify no part of the case gets too hot, but ABS would be the more temperature resistant choice if you want to play it safe.

For a full component list and build instructions, check out my reddit post: https://www.reddit.com/r/Dynavap/comments/c9gch4/diy_3d_printed_dynavap_induction_heater_open/