Dynavap Induction Heater

This is my take on a dynavap induction heater. the parts list below cost a total of around 35-40$ to build your own working IH. The glass tube for the induction heater needs to be bought in a quantity of 3 so i bought one 14-18mm for the induction heater and two 10mm-14mm to fit the dynavap into any 14mm device. You will also need to purchase extra wire, I just went to my local hardware store and got a couple of feet of 20 awg wire for a couple bucks. Screws are random 3mm screws i had laying around. I did solder the coil to the heater and the one wire into the mosfet but it was pretty simple. I do not think that it will fit inside of this enclosure if you do not solder. there is also a cork in the bottom of the glass to stop the dynavap at a certain height.

Wiring the IH:
Refer to this picture from jojo04201 on Reddit
https://i.imgur.com/SZZqDiJ.jpg
Plug Vin+ into the + terminal on the kastar plug and Vin- into the - terminal on the plug
out+ goes to the + terminal on the ind