Dyson Attachment Bracket
von seanburlington
3
Downloads
2
Likes
0
Makes
There are a few of these around now - I've been working on this on and off for ages so I figured I may as well finish it
The fit is slightly loose to allow for printer wobbles - you could tighten it up a bit if you have good enough print quality
Version number marked on the unit as I lost track of which prototype was which (it's printed on the underside so doesn't show)
This is my first go at openscad so the code is messy - but source code included in case anyone wants to edit it.
https://github.com/seanburlington/3Ddesigns/blob/master/dyson-bracket.scad
The fit is slightly loose to allow for printer wobbles - you could tighten it up a bit if you have good enough print quality
Version number marked on the unit as I lost track of which prototype was which (it's printed on the underside so doesn't show)
This is my first go at openscad so the code is messy - but source code included in case anyone wants to edit it.
https://github.com/seanburlington/3Ddesigns/blob/master/dyson-bracket.scad
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
