E2_Standoff

Rev. 1 / v9
Wanted a basic filament guide for my Ender-2 so I whipped this up. The installed picture shows v1 in use. Several changes were made to clean up this design and is what I have posted v9.

You should be able to use the existing hardware however I would suggest maybe bumping up from the 8mm to 12mm.

Thanks for looking. I welcome any comments or suggestions as I am new to 3D printing and this site.

I have posted the Fusion file as well as the STL.

Rev. 2 / v12
Watching this thing in action, I decided to reduce some of the material and push the guide hole over 4cm to hopefully stop the filament from rubbing on the Z screw. I also added a smoother area in the guide hole because of the offset from center.