Thingiverse
E3D Insert
von Pmenuez
19
Downloads
15
Likes
0
Makes
A filament guide insert for a E3D extruder.
I made the Davinci to E3D conversion but was frustrated with loading the filament. The extruder I purchased (knockoff) had a Bowden PTFE connector that made it difficult to load filament.
I created this insert to ease my pain. As you will see in the cutaway picture the throat is tapered from about 5 mils to about 2 mils.
This makes loading the filament pretty easy.
I made the Davinci to E3D conversion but was frustrated with loading the filament. The extruder I purchased (knockoff) had a Bowden PTFE connector that made it difficult to load filament.
I created this insert to ease my pain. As you will see in the cutaway picture the throat is tapered from about 5 mils to about 2 mils.
This makes loading the filament pretty easy.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!