Thingiverse
E3D Volcano adapter for FT-5
von JMecky
11
Downloads
8
Likes
1
Makes
Volcano adapter for FT-5.
This design allows you to use the same screws used to hold original fan down.
I have used this on 30 hr prints with no problem
Intentional 1.5 mm gap left between part to allow clamping action on E3D heat sink.
This design allows you to use the same screws used to hold original fan down.
I have used this on 30 hr prints with no problem
Intentional 1.5 mm gap left between part to allow clamping action on E3D heat sink.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
