Slicer Discord
Eachine Airloader Vortex Generator – 3D-Druckmodell von Thingiverse Thingiverse

Eachine Airloader Vortex Generator

1 Downloads
1 Likes
0 Makes
Zum Modell
Vortex Generators for the Eachine Airloader. The plane is a little tipstally if you get your airspeed too low. These take care of it. I just install them on the outer half of the wing, and they seem to work. They are installed angled 15 degrees, and the tips of the VGs start 3cm from the leading edge of the wing.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

4 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen