Slicer Discord
Ear stand – 3D-Druckmodell von Thingiverse Thingiverse

Ear stand

44 Downloads
40 Likes
1 Makes
Zum Modell
I did it for my daughter (also the crazy colors). It has room for up to 64 stud earrings. The holders can lie in the shell and they are protected from falling out by the green covers. The subjects are so big that my daughter can reach in well. For me it would be too small with my stubby fingers :-(.
I've made a second version with bigger holes. the holes have a hopper and are a little bit bigger at the top, so the earings could be placed easy and have a hold if the stick insight.
One has 2 areas with radius 0.7-0.5 mm (lower) and 0.6-0.4 mm (upper). The other has 2 with radius 0.9-0.7 mm (lower) and 0.8-0.6 mm (upper).
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

masselkopp veröffentlicht auch auf

36 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen