Thingiverse
Earbud Headset
von elijahmock
14
Downloads
24
Likes
0
Makes
This is a design to make your own DIY headset with just some simple earbuds! This method is much cheaper than buying an actual headset.
If your microphone is too quiet and you can't turn it up any louder, this print is for you. The earbud headset holds your microphone on your earbuds closer to your mouth so your device can hear you better.
This is a simple two-piece print that is easily assembled and ready to go right away. Just pop in your earbuds, and easily remove them when you are done.
The earpiece should be printed in flexible filament in order to allow __fit for any size ear__.
If your microphone is too quiet and you can't turn it up any louder, this print is for you. The earbud headset holds your microphone on your earbuds closer to your mouth so your device can hear you better.
This is a simple two-piece print that is easily assembled and ready to go right away. Just pop in your earbuds, and easily remove them when you are done.
The earpiece should be printed in flexible filament in order to allow __fit for any size ear__.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
