Thingiverse
earring support
von xavierm2010
11
Downloads
16
Likes
1
Makes
This is a support that can hold long and short earring
the grid is not on the model but it's the infill with a high % (1,5mm) with no top or bottom
the grid is not on the model but it's the infill with a high % (1,5mm) with no top or bottom
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
