Easy-Grip Ring Pull Helper, Tab Puller

Tired of hurting your fingernails or struggling with tight can tabs? This is a simple, ergonomic tool designed to open any ring-pull can (soda, soup, pet food, tuna) with ease. Recomended material: PetgI have prepared two separate print plates for your convenience:Standard Version: without magnets.Magnet Version: Designed for a D10 x 1.5mm round magnet.Important - Magnet Installation: For the magnet version, I have pre-configured a pause at Layer 14. When the printer pauses, simply drop the magnet into the slot and resume the print. The magnet will be fully encased (hidden) inside the tool for a sleek look!Support Information: I have optimized the supports to be as easy to remove as possible. However, I still recommend being careful when removing them from the opener.Tip: Use a thin, hard tool (like a small flathead screwdriver, tweezers, or a hobby knife) to gently pry the support material out of the opening.