Easy printer light upgrade

I recently ran across this video (link at bottom) from JW 3D FORGE detailing an quick, clean and $10! way to install an light bar in the P1S, PIP, or X1. Get the light bars here: https://amzn.to/3CZXuG6 His clear and easy instruction video is below. The only things I did differently were: Design and print some clips to angle the lights down. They attach in the same place as JW shows plus one more attach point at the back of the printer. Use the allen key that came with your printer to temporarily remove the screws and attach the clips. Route the USB out the back to and use the power block supplied with the LED light bar instead of using the P1S's internal USB. If you have an enclosed printer, you'll need a riser of some sort to do this as there are no holes in the enclosure. I used this excellent slim riser https://makerworld.com/en/models/798702#profileId-738283 along with the AMS holder https://makerworld.com/en/models/836437#profileId-781797If you use this one, you'll ne