Echo Dot Microphone

I have printed all of the parts and assembled a model which is shown. The "Dome" cover will fit over the Base Plate, and in turn a 1/2" piece of sprinkler pipe will fit over the tabs in the center of the Base Plate. The Mic Holder will fit over a Gen 2 Echo Dot.

Fit of the parts is entirely dependent upon the printer. These parts fit together as printed on MY CR-10s modded printer and SHOULD fit together when printed on your printer what ever it is. None of the parts are over 150mm so they should print on almost every printer out there.

This design has only six printed parts, seven if you should choose to print the pipe, BUT, and a big but it is, a section of sprinkler pipe is so much easier to simply cut to size and paint, I highly recommend AGAINST printing the pipe, although I have included an .stl for one if you do decide to go that route. It was created and sized in Tinkercad and SHOULD be a good copy of a sprinkler pipe, but I do not guarantee it. I bought a sprinkler pipe