Thingiverse
ECU Dome
von Jaybird21
21
Downloads
17
Likes
0
Makes
This is a personal project I created using SolidWorks. It is based on the Cupola dome at East Carolina University. Go pirates!! Enjoy!!!!
Keep the support and raft on for best product. The ECU letters on the bottom may not print without support.
I would not set the infill above 30% for time and material consumption reasons.
The smallest I would recommend printing would be half size and be careful not to accidentally break the top part off.
Keep the support and raft on for best product. The ECU letters on the bottom may not print without support.
I would not set the infill above 30% for time and material consumption reasons.
The smallest I would recommend printing would be half size and be careful not to accidentally break the top part off.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
