Thingiverse
Egg - lateral
door cbbosse1
5
Downloads
3
Likes
0
Makes
The egg is printed in two pieces, please glue the pieces using model cement. Then have fun with it!
The original egg is about 95,25 mm (3.75") long, and about 76.2 mm (3") wide. The model shown was printed in white, given a coat of white primer, and then a clear coat. The flower was done on a Silhouette cutting machine. Last, I put a piece of thin ribbon around the outside to hide the seam.
The large egg is about 120 mm x 93 mm.
The original egg is about 95,25 mm (3.75") long, and about 76.2 mm (3") wide. The model shown was printed in white, given a coat of white primer, and then a clear coat. The flower was done on a Silhouette cutting machine. Last, I put a piece of thin ribbon around the outside to hide the seam.
The large egg is about 120 mm x 93 mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
