Thingiverse
Egg - lateral
von cbbosse1
5
Downloads
3
Likes
0
Makes
The egg is printed in two pieces, please glue the pieces using model cement. Then have fun with it!
The original egg is about 95,25 mm (3.75") long, and about 76.2 mm (3") wide. The model shown was printed in white, given a coat of white primer, and then a clear coat. The flower was done on a Silhouette cutting machine. Last, I put a piece of thin ribbon around the outside to hide the seam.
The large egg is about 120 mm x 93 mm.
The original egg is about 95,25 mm (3.75") long, and about 76.2 mm (3") wide. The model shown was printed in white, given a coat of white primer, and then a clear coat. The flower was done on a Silhouette cutting machine. Last, I put a piece of thin ribbon around the outside to hide the seam.
The large egg is about 120 mm x 93 mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
