Eggs

Plain solid eggs in varying sizes (mini, small, medium, large). Each egg is printed in two halves, a top and a bottom, and are held together using a permanent locking pin. No adhesive or supports are needed. I printed the eggs using PETG but any filament should work. No supports are necessary. I used the default settings (Bambu Studio) for the “0.16mm Optimal @BBLX1C” system preset except for the following:Quality > Seam > Seam position: RandomQuality > Advanced > Order of walls: outer/innerStrength > Walls > Wall loops: 4Strength > Top/bottom shells > Top shell layers: 3Strength > Top/bottom shells > Bottom shell layers: 5Strength > Sparse infill > Sparse infill pattern: Adaptive CubicSpeed > Other layers speed > Outer wall: 50Speed > Other layers speed > Inner wall: 150 Because every spool of filament can vary in composition, you may have to adjust the locking pin slot/hole size using the X-Y hole compensation setting. I suggest adjusting the setting by (+/-) .1mm increments to get t