Eibos Cyclopes Drying Rack

I wanted to dry silica gel packets in my Eibos Cyclopes filament dryer so I designed this simple drying rack to fit inside and stack so there's two layers. There's room for a third layer, if required.

I printed it in ASA so it would withstand the highest temperature of the dryer. I didn't have any issues with it sagging in the middle while loaded with 50g packets at maximum temperature for several hours.

I haven't tested with PETG, but it may just about suffice at maximum temperature. I wouldn't recommend PLA, but it may just about work for PLA drying temperatures.