Thingiverse
Einhell Pump guard
door gedm
2
Downloads
0
Likes
0
Makes
My dirty water pump (Einhell RG-DP 1135N) was sucking up stones which where becoming stuck in the outlet pipe. These grates snap into the water inlets and stop the larger stones getting through.
The rear and side (rear) are the same dimensions. The snaps go along the top and bottom of the inlet hole. The front is a wider inlet. I have provided STLs for individual prints and one to print all 6 at the same time.
If you find the sizes aren't quite right , or your pump is a little different, try resizing in your slicer. They might still work.
I made this on Tinkercad, so if you want the CAD files you can get them there.
The rear and side (rear) are the same dimensions. The snaps go along the top and bottom of the inlet hole. The front is a wider inlet. I have provided STLs for individual prints and one to print all 6 at the same time.
If you find the sizes aren't quite right , or your pump is a little different, try resizing in your slicer. They might still work.
I made this on Tinkercad, so if you want the CAD files you can get them there.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!