Thingiverse
Elcan killflash kit
von Gregory74
21
Downloads
12
Likes
0
Makes
Print it, and clip on your Elcan scope & RMR red dot.
It is a tight fit for the scope, so maybe you'll have to trim the edges a little bit.
To put the red dot firmly in place, you'll need to bend slightly the sides while heating the pla (i use a standard hair dryer)
I bend it in order to have 1cm space between the two sides.
It is a tight fit for the scope, so maybe you'll have to trim the edges a little bit.
To put the red dot firmly in place, you'll need to bend slightly the sides while heating the pla (i use a standard hair dryer)
I bend it in order to have 1cm space between the two sides.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
