Thingiverse
Gadgets
Go to Model
Elden Ring Logo
194
Downloads
152
Likes
3
Makes
Elden Ring logo as seen on the presentation of June 10th 2021, been waiting a while for this one. Both versions can be printed without supports or bed adhesion supports.
To paint mine I used some gold spray paint (Arexons, Oro Diamantato)
Stay hyped fellow tarnished
*Not for commercial use, the rights of the elden ring logo belong to "From Software"
Printing:
Layer Height : 0.2 will do fine
Infill : 30% is enough, for use as a necklace, it may be increased
About 5mm of height should be enough
Depending on which filament and settings are used it may be necessary to clean up some stringing
To paint mine I used some gold spray paint (Arexons, Oro Diamantato)
Stay hyped fellow tarnished
*Not for commercial use, the rights of the elden ring logo belong to "From Software"
Printing:
Layer Height : 0.2 will do fine
Infill : 30% is enough, for use as a necklace, it may be increased
About 5mm of height should be enough
Depending on which filament and settings are used it may be necessary to clean up some stringing
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
