Thingiverse
Gadgets
Vai al Modello
Elden Ring Logo
194
Download
152
Likes
3
Makes
Elden Ring logo as seen on the presentation of June 10th 2021, been waiting a while for this one. Both versions can be printed without supports or bed adhesion supports.
To paint mine I used some gold spray paint (Arexons, Oro Diamantato)
Stay hyped fellow tarnished
*Not for commercial use, the rights of the elden ring logo belong to "From Software"
Printing:
Layer Height : 0.2 will do fine
Infill : 30% is enough, for use as a necklace, it may be increased
About 5mm of height should be enough
Depending on which filament and settings are used it may be necessary to clean up some stringing
To paint mine I used some gold spray paint (Arexons, Oro Diamantato)
Stay hyped fellow tarnished
*Not for commercial use, the rights of the elden ring logo belong to "From Software"
Printing:
Layer Height : 0.2 will do fine
Infill : 30% is enough, for use as a necklace, it may be increased
About 5mm of height should be enough
Depending on which filament and settings are used it may be necessary to clean up some stringing
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
