Thingiverse
Electric screwdriver
door Citrionyx
1.8k
Downloads
1.9k
Likes
1
Makes
3D printed electric screwdriver
Gear ratio 25:1
Just enough torque for smartphones and such with more speed than an average commercial screwdriver of similar type.
It requires:
.Powerful type 130 dc motor (peak current of mine at 4 volts is about 3 Amps)
(Also as it turns out stock brushes of this motors last for about a week)
I upgraded mine with graphite brushes i took from another motor. Yet to find out how long that would last.
. 18650 lithium-ion cell
. Lithium cell protection board
. Couple of buttons
. H bridge motor controller (i used TA6586)
. Micro USB
. Some litium battery charging chip
https://youtu.be/RLfWq7SbDRI
https://youtu.be/-XGgju4UsTU
Gear ratio 25:1
Just enough torque for smartphones and such with more speed than an average commercial screwdriver of similar type.
It requires:
.Powerful type 130 dc motor (peak current of mine at 4 volts is about 3 Amps)
(Also as it turns out stock brushes of this motors last for about a week)
I upgraded mine with graphite brushes i took from another motor. Yet to find out how long that would last.
. 18650 lithium-ion cell
. Lithium cell protection board
. Couple of buttons
. H bridge motor controller (i used TA6586)
. Micro USB
. Some litium battery charging chip
https://youtu.be/RLfWq7SbDRI
https://youtu.be/-XGgju4UsTU
Citrionyx publiceert ook op
6 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!