Thingiverse
Electronics enclosure
door bweber0204
2
Downloads
1
Likes
0
Makes
This is a electronics enclosure designed for a MKS gen L boards and mean well power supply
Designed to be tapped with M6 threads for the cover and 2 80 MM fans for cooling. The parts are quite large and and need a bigger printing area. If there is enough interest i will re-design for smaller print beds. I used a URBEST 10A 250VAC switch from amazon and that is what the rectangle on the front opposite the honeycomb side is for. I used 4 bottom and top layers for the cover because it is so big any less with 30% infill it gets to be to flimsy. If nothing else this is very good test to see how well you can level your bed. Flip the main body of the enclosure 180 degrees for printing
Designed to be tapped with M6 threads for the cover and 2 80 MM fans for cooling. The parts are quite large and and need a bigger printing area. If there is enough interest i will re-design for smaller print beds. I used a URBEST 10A 250VAC switch from amazon and that is what the rectangle on the front opposite the honeycomb side is for. I used 4 bottom and top layers for the cover because it is so big any less with 30% infill it gets to be to flimsy. If nothing else this is very good test to see how well you can level your bed. Flip the main body of the enclosure 180 degrees for printing
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
