Thingiverse
ELFA-Compatible Corner Bumper
por JGlass
8
Descargas
6
Likes
0
Makes
After my partner nearly beaned herself on a protruding corner, I designed this to soften the blow from solid ELFA shelving. These should fit any 3/4" Melamine shelves. The tolerance is close enough that they stay on the corners without any additional adhesive.
They print upright with supports, but the interior angle is minimal enough that the support is really just for the little notches on the sides.
They print upright with supports, but the interior angle is minimal enough that the support is really just for the little notches on the sides.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
