EMT Electronics Flat Mount

Inspired by the EMT Conduit Case by Steep, and remixing parts from Allted's Conduit clamps and his End Stop Mounts, I created a place to bolt on my raspberry pi, and a 7in touchscreen monitor. I am still working on my software, but the plan is for this to be a network monitor, so I can tell at a glance which parts of my Internet and network might be broken.

The STLs are just the "left" side, which you can mirror in your slicer to get the other side. The clamp_left is the part that attaches to the stuff, and the end_left holds the EMT conduit in place. The clamp parts can also be installed with the mount closer to the board, like I did for the pi, which gives a little more flexability in the depth.

If you have a 7in touchscreen (I have the waveshare) then the adjustable mounts are the same size, and you can build it just like I have. Then you can attach whatever electronics with the slots.