Thingiverse
End stop Switch Bracket
von Craz3Coyote
13
Downloads
7
Likes
0
Makes
This is the end stop switch bracket that goes on top of FlightFixit 3d Delta printer.
The bracket is for the Makerbot stop switch v3. The holes in bracket are so you can see the light come on for troubleshooting purposes.
You also can adjust it to get the stop switch in the right spot.
The bracket is for the Makerbot stop switch v3. The holes in bracket are so you can see the light come on for troubleshooting purposes.
You also can adjust it to get the stop switch in the right spot.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!